4
1124487-W2-A
4. fit a hanger bracket onto the end of each rail.
5. Position the rail assemblies into the cabinet running front-to-back.
6. Measure the overall width of your sink. This distance represents the distance
″A″ between the outside edges of the rails as shown in the illustration.
7. Position the hanger brackets according to distance ″A″ and mark the screw
hole locations onto the cabinet.
8. drill 3 mm starter holes at each marked location.
9. secure the hanger brackets in position with suitable screws.
10. lower the sink into the cabinet. Make sure that the sink is supported by the
undermount kit.
11. Make sure that the sink is level, make any adjustments as necessary using the
screws located at each corner of the sink.
12. Install the countertop.
Wipe Away Excess Sealant
Apply Silicone Sealant
13. Apply a thin bead of silicone sealant where the sink meets the countertop.
Immediately wipe away any excess sealant with a damp cloth. fill any voids if
needed.
14. Allow the sealant to cure for at least 30 minutes before proceeding.
