3. Install the Centerguide
Measure the center of the threshold. Mark the centerline near the groove on the inside surface of the
threshold.
IMPORTANT!
Drill through the inside surface only.
Drill a 1/8
″
hole at the centerline on the groove of the inside surface of the threshold.
Install the centerguide clip to the threshold with the supplied #6 x 3/8
″
screw.
Press the centerguide over the clip. Make sure the centerguide is completely installed with the tabs
snapped under the bottom of the threshold.
Inside
Surface
Tabs
Groove
1/8"
(3 mm)
Hole
1380408-2-B
6
Kohler Co.