Kohler 1071003-2-B, Руководство по установке

Страница: 5 / 28

3. Assemble the Unit
Install Shelves
Insert a filler strip down into the left and right channel.
With the tab of the clip pointing up, snap a clip above each filler strip.
NOTE: The top filler strip will extend above the unit.
Repeat this process for the remaining strips and clips.
Temporarily insert a shelf above each set of clips to verify the clips are properly aligned. Adjust the
clips as needed.
Remove the shelves and set aside.
Inspect each channel, making sure the filler strips and clips are flush against each other.
Mark the top filler strips 1/16
″
(2 mm) below the edge of the columns.
Remove the marked filler strips.
Cut at each mark with a 32-tooth per inch hacksaw.
Reinsert the cut filler strips.
Snap the top cap into place on the top of the unit.
Partially thread a screw into each of the four screw holes on the top cap.
WARNING: Risk of product damage. Do not overtighten the screws. Once the rubber seal in the
top cap is compressed, the tightening resistance will increase.
Alternating between screws, completely tighten the screws to secure the top cap to the column.
1/16"
(2 mm)
Filler
Strip
Cut
Line
Screws
Top Cap
Screw
Clamp
Tab
Filler Strip
Filler
Strip
Clip
Filler Strip
Install Shelves Install Top Cap
Kohler Co. 5 1071003-2-B