Kogan KAUNDMTRNGA, Инструкция по эксплуатации / Руководство по установке

Страница: 11 / 16

11
FAQs & Troubleshooting
OPERATION IN CASE OF EMERGENCY
In the event of an emergency you should:
•
Switch off all rangehood controls.
•
Switch the rangehood off at the power outlet and immediately unplug.
•
Call Kogan After Sales Support on 1300 256 426.
Some minor faults can be fixed by referring to the instructions given in the Troubleshooting section
below.
IMPORTANT!
If your appliance appears to be operating incorrectly, then you should disconnect it from your
electrical supply and then contact Kogan After Sales Support on 1300 256 426.
WARNING!
Do not attempt to repair the rangehood yourself.
Please note that if a technician is asked to attend whilst the product is under warranty and finds
that the problem is not the result of an appliance fault, then you may be liable for the cost of the
call out charge.
The appliance must be accessible for the technician to perform any necessary repair. If your
appliance is installed in such a way that a technician is concerned that damage will be caused to
the appliance or your kitchen, then they will not complete a repair. This includes situations where
the rangehood has been tiled in or sealed in with a sealant.
Please refer to the conditions of that appear on the warranty card at the rear of this user manual.
FAULT COMMON CAUSE COMMON SOLUTIONS
The lights work,
however the
motor does not
work. The motor is blocked or
jammed. Call After Sales Support for
further guidance.
The capacitor is damaged. Call After Sales Support for
further guidance.
Neither the
lights or the
motor works. Beside the above mentioned, check the following:
Light globes are damaged
or blown Call After Sales Support for
further guidance.
The power cord is loose. Ensure that the rangehood is
correctly plugged in and the
power outlet is switched on.
The rangehood
is vibrating
against the wall. The rangehood canopy
is not fixed to the wall
correctly. Ensure that the internal safety
screws have been used and are
tight.
Insufficient
suction. The distance between
the rangehood and your
cooktop is too great. Have your installer re-adjust the
installation position, ensuring
that
the minimum distances are
observed as per the building
code.