12
1)
Turn on the brush switch to activate the brush.
2)
To empty the dust bin, turn the power off and pull the dust bin from the side of head.
Empty it into a trash can. The dust bin may be warm to touch.
3)
Replace the dust bin by pushing it back into the head until it snaps back into place.
Steam cleaning floors
1)
Select one of the following steam regulator positions:
1-Low, 2-Medium, 3-High and 4-Hot Spray.
•
1-Low and 2-Medium settings: Ideal for cleaning all hard floors, such as linoleum,
ceramic, marble, wood, etc.
•
3-High settings: Ideal for cleaning carpets and rugs.
•
4-High spray settings: Ideal for cleaning bathroom, kitchens, windowsills, car
wheels, etc.
You can change the steam regulator position and change the steam output while
operating the steam mop sweeper.
2)
Once the unit has been fully assembled and filled with water, plug in the power cord to
a grounded electrical outlet. Steam switch (O/I) is in the OFF (O) position, turns the steam
switch (O/I) to the ON (I) position. Approximately after 8 seconds, the mop will start
emitting steam. Adjust the steam regulator according to your requirement. To stop
emitting steam, you need to turn off the steam switch. Make sure to turn the unit totally
OFF after each usage and disconnect from the electrical outlet so the unit is in the totally
OFF status when used next time.
3) Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt
loosened by the steam. Apply steam liberally. Keep a towel handy and wipe away any
excess water that may accumulate.
4) When the steam cleaner stops emitting steam, simply turn OFF and unplug the
appliance, refill the water tank and continue cleaning.
Never leave the steam cleaner unattended while plugged in. For best results:
1.
Sweep or vacuum floor prior to using the mop.
2.
To avoid pudding of water, the microfiber cloth must be clean and dry for use. To
replace the cleaning cloth, proceed as follows: Let the cleaning cloth cool down,
remove the cloth from unit, replace with a new microfiber cloth and continue use.
Select low steam regulator position.
3.
To sanitise an area of your floor, leave the steam cleaner at high steam setting over
the steam area for about 10 seconds, but not more than 15 seconds.
Do not carry out this procedure on heat and steam sensitive floors.
Содержание KASWPSTM11A
Страница 4: ...4 Overview ...
