Use and Control
1. The aircraft power cord and the battery cord
should be connected as shown on page 1. Correct
these together while the helicopter is sitting on flat
ground.
2. After about 6 seconds, the LED lights will be
flashing. To pair the controller and the helicopter,
push the throttle stick to the bottom, then turn the
power switch to ON. Immediately push the throttle
stick up to the maximum, then back down to the
bottom. Upon completion of these steps, the
aircraft can be operated.
IMPORTANT
: The white blades should be on the front side of the copter, while the black
blades should be on the rear side.
Push the throttle up, and the
speed of the blades will
increase. The copter will begin
to ascend.
Pull the throttle back, and the
speed of the blades will
decrease. The copter will
begin to descend.
Push the rudder stick to the
left, and the copter will turn
left.
Push the rudder stick to the
right, and the copter will turn
right.
When the rudder stick is
pressed upward, the copter
will tilt and move forward.
When the rudder stick is
pulled back, the copter will
tilt back and reverse.
When the rudder is pressed
to the right, the copter will
fly to the right.
When the rudder is pressed
to the left, the copter will fly
to the left.
Push the controls slowly to ensure you have adequate control of the copter.
3
