Kogan KAHTP20WHTA, Быстрый старт

Страница: 5 / 12

Foot Assembly
Put the feet into the heater’s housing, then secure them with the supplied ST4 3x10 screws.
To move the appliance, switch it off and disconnect it from the power mains, then wait for
the heater to cool down.
Use the side gripping points for transport.
Wall Assembly
Note that the heater must be installed at least 15cm above the floor and 50cm below the
ceiling.

Make two holes (515mm apart for the 2000W heater)

With a diameter of 8mm and a depth of 40mm, insert the supplied anchors in the
holes, then use a screwdriver to tighten the screws supplied with the anchors.
These screws must protrude from the anchor. You can then hang the heater using
the hook holes on the back of the unit.
ASSEMBLY
Note:
Before drilling, make sure there are no wires or pipes located under the wall.