5
Getting Started
1. Connect the aerial or input source to the appropriate input socket at the rear of
the TV set (see page 4).
2. Connect the small round plug on the power adaptor cable to the power input
socket at the rear of the TV set.
3. Connect the power cable between the power adaptor and the mains supply.
4. Turn on the TV Power switch under the right hand speaker.
5. Switch the TV on by pressing the
POWER
button on the front panel or the
remote control (the
LED
will show green).
6. Use
the
AV/TV
button on the front panel or the remote control to select which
input source to use : TV-AV-SVIDEO-YPBPR1-YPBPR2-VGA-HDMI
7. You can use the front panel controls to adjust the volume or select a channel as shown
below, or you may use the remote control for these functions.
8. To switch the set off for a short time, press the
POWER
button, the set will go into
standby and the
LED
will show red. If you are not going to use the set for some
time, switch the power off completely by unplugging the mains cable.
Front panel controls
