Using the Device
1.
Plug the power cord into a power outlet. Turn on the power supply. Press the power
button.
2.
The steaming will start after 20 seconds. When steaming, the water droplets may
spill out. This may be caused by adding too much water. Ensure to use the
measuring cup to add water. Do not exceed the marked ‘MAX’ water level line
(50mL).
Note:
To reduce risk of burns, it is recommended to use 40-45mL of water per use.
Exceeding the maximum capacity may cause water to splash and create risk of
burning.
3.
To ensure the steam covers entire face, keep the face 20 cm (or more) away from
the nozzle edge.
4.
When the amount of water is insufficient, the steam will be weakened. When the
water in the tank is completely used, the releasing of steam will stop. Average use
time is 8-10 minutes, to empty all water.
5.
If you want to continue using the device, then turn it off, wait for 10 minutes before
you to use the device again. Follow the instructions in this section.
6.
After steaming, turn off the device and the power supply. Store it after it cools down
completely. Moisturise your face skin, otherwise your face may feel dry.
Operation Advice
•
Recommended steaming session length is 8-10 min of continuous use, which is
equivalent to approximately 45mL of water. This will ensure the water tank is
completely emptied and ready for next use.
•
After each use, ensure all excess water is emptied. Failure to do so may cause:
•
Bacteria developing in residual water, unhygienic for future use
•
Accidentally overfilling water tank for future use
OPERATION
Содержание estelle ESIONFCSTMA
Страница 1: ...NANO IONIC FACE STEAMER HUMIDIFIER ESIONFCSTMA...
Страница 2: ......