Koden MDC-5204, Руководство по установке

Страница: 65 / 182

MDC-5200/5500 Series Chapter 3 Installation method
0092655002-03 3-41
3.4.5 Connecting a Position, Speed or other device of NMEA in/out
An initial value of the I/O baud rate of the port is as follows.
J3: 38400 bps (IEC61162-2)
J5: 4800 bps (IEC61162-1)
J6: 4800 bps (IEC61162-1)
The I/O baud rate can switch 4800, 9600, 19200 or 38400 in the radar menu.
[MAINTENANCE] => [I/O] => [BAUDRATE]
The sentence input to these ports is shown below.
Position information: GLL, GGA, GNS, RMC, RMA
Heading information: THS, HDT, HDG, HDM, VTG, RMC, RMA
Speed information: VBW, VTG, VHW
Set and drift: VDR
Waypoint information: RMB, BWC, RTE, WPL
Routes: RTE, WPL
Cross-track: RMB, XTE
Datum: DTM
Depth: DBT, DPT
Temperature: MTW
Date: ZDA, RMC, GGA
LOP: GLC
Wind: MWD
ROT: ROT
These sentences can select the port of each sentence input in the radar menu.
The output port is J3, J5 and J6 ports. As for the J6 port, the transmission cycle is set at 0 seconds and
not output by default. The J5 port is output TTM sentence in a cycle for 1 second by default.The J3 port
is output at the following cycles.
EVE=1.0s, HBT=5.0s, OSD=1.0s, RSD=1.0s, TLB=5.0s
J7
Figure 3.22 Cable connection for J5 and J6 or Log
J3, J5 & J6
Pin number CW-376 wire
color Signal
name
1 Blue+shield Shield
2 White OUT-A
3 Red OUT-B
4 Orange IN-A
5 Black IN-B
6 Green
J3, J5:12V
J6:NC
J5
J6
1
2
3
4
5
6
Cable connector pin assignment
J5
J6
NMEA device 1
NMEA device 2
NMEA device 3
J3