Kodak EKTASOUND 235, Руководство пользователя

Страница: 12 / 18

operating
tips
The perforations in the
film
should be toward you
as
the
film comes off the supply reel clockwise. If they are not, the
has not been rewound or was twisted while being re-
wound.
If the picture is unsteady, it can be due to torn perforations
in the film.
you are not getting any sound while projecting a
magnetic-striped sound film, check to make sure:
Film
is
wound correctly on supply reel.
Volume control is set at a listening level.
If
the sound is distorted, check to make sure:
Speed control is set at the proper
film
speed (18 or
24
ames per second).
Volume is not too high.
The
PLAYBACK HEAD
is self-cleaning (see illustration under
"Cleaning Projection Lens," page 10). The movement of film
across the head is to keep it clean.
Also, your projector mechanism has bearings that require
no oiling.
replacing lamp
Your projector is equipped with an 80-watt, 30-volt, code
DFE
projection lamp with a rated life of 15 hours. It's a good
idea to keep a spare projection lamp on hand. You can pur-
chase lamps from your photo dealer.
If the lamp should burn out during projection, accelerate
lamp cooling by running the projector in the .STILL position.
After cooling, turn off the projector and proceed as follows:
1. Disconnect the power plug from the wall outlet.
2. Grasp the top edge of the located a t the rear
of the projector, and pull it away from the projector.
3.
Pull the
L E VE R
toward you.
(This
releases
the
PROJE C TION LAMP
from the socket.) Lift out the lamp.
4. Install a new lamp (80-watt, 30-volt, code DFE) by hold-
ing
it so that the shiny side of the reflector
in
the lamp is
toward the lens (away from you). Place the center post of
the lamp in the center hole of the socket. Rotate the lamp
slightly until the key on the lamp center post drops in the
socket slot.
5. Press the lamp down
all
the way.
PROJECTION
LAMP
LEVER