Troubleshooting
www.kodak.com/go/support
45
Camera ready light status
Picture is too light
■
Reposition camera to reduce the amount of available light.
■
Turn flash off (
page 26
).
■
Move so that the distance between you and the subject is within the
effective flash range (
page 9
).
■
To automatically set exposure and focus, press the Shutter button
halfway
. When the Ready light glows green, press the Shutter
button
completely down
to take the picture.
■
Use Auto, Landscape, or Close-up to adjust the exposure
compensation.
Picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway
. When the Ready light glows green, press the Shutter
button
completely down
to take the picture.
■
Clean the lens (
page 59
).
■
Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If...
Try one or more of the following
Ready light does
not turn on and the
camera does not
work
■
Turn on the camera (
page 2
).
■
Recharge the battery or install a new one (
page 1
).
■
Mode dial was on when battery was reloaded. Turn Mode dial off, then
back on.
Ready light blinks
green
■
Picture is being processed and saved to the camera. Camera is
operating normally.
■
Camera is connected. Camera is operating normally.
Ready light blinks
red and camera
turns off
■
Recharge the battery or install a new one (
page 1
).
If...
Try one or more of the following
