3
REASSEMBLY
7. Reassemble in the following order:
Position door and handle. Make sure that the handle is sitting comfortably – it can only go in one way.
Place the cover on the top and butt the screws in without tightening them.
Position fan vent, tighten back screws first and then front screws
Put lens cover back in place.
8. Replace the optics and lamps, IN ORDER, A, B, C, D, E. (E) with mirror facing front, (C) with lens
facing front, (B) with glass facing front, (E) with lens facing back.
9. The back mirror (E) is tricky to put back in its position.
10. The condenser lens (A) should go in the penultimate groove closest to the lens so that the last groove
remains empty. (this is only used for 40 x 40 mm square aperture slide mounts)
CENTERING THE LAMP
Having changed the lamps it is necessary to align them properly.
11. After switching off the projector, look through the lens and check the position of the lamp filament
12. In the shipment included (see accessories case) is a slide mount which contains a piece of card with
a pinhole pushed exactly in the centre. Place this slide inside the gate and switch on the projectors.
13. Using this mount, you can see whether the lamp is aligned properly. The two images of the lamp
should be vertically aligned and not overlapping. This can be controlled by the adjustment screw on
the lamp holder. (See picture with open lamp house door above)
14. In the end, make sure that the lever is pushed all the way back into place.
CHECKLIST
If any problems are encountered with the projectors during the following checks, refer to the operating
manual for troubleshooting.
1) Check Dial on bottom is set to 240v
2) Check fuse (below on /off switch) is 250v 1.6A
3) Run projector and listen for noises e. g. fan squeaking
4) Run test carousel and timer
5) Check legs are extendable
6) Remove lens
7) Turn over and open up, while doing so check that handle, grill, face plate and door are in place
8) Remove all optics, front to back, and lamps. Dust and clean
9) Clean and dust inside of projector – use compressor if necessary
10) Oil fan wheel
E D C B A
wrong alignment
correct alignment