ALWAYS UNPLUG THE MACHINE BEFORE INSTALLING ANY ACCESSORY.
THIS MACHINE WORKS WITH A 3 LUG DRIVE SYSTEM.
1.
Unplug machine, secure handle tube in vertical position and lay down the machine turning it over its
wheels until the underneath side of the machine is vertical and fully exposed.
2.
Before laying down machine, place a clean towel on the floor to keep the switch box from scratching.
3.
Place the driver by positioning the three slots of the plate over the three lugs of the drive plate. Turn
the drive counterclockwise as far as it will go. The brush is placed in a similar way.
4.
To remove the driver or brush, disengage clutch plate slots from drive plate lugs by turning clockwise.
If you encounter difficulty to remove, apply foot pressure to the brush until it moves clockwise.
5.
Do not operate this machine without brush or drive and pad in place.
6.
To place a pad, lay it down on the floor first, tilt machine over its wheels, so that the machine goes over the
pad, center the drive and pad and let the machine down over it. Your floor machine is ready to be used.
Note: The scrubbing pad can be used with the pad driver or with the scrubbing brush.
1.
Place the driver and pad or brush, plug the power cord into a proper grounded outlet.
2.
Disengage the handle release lever by lifting it up, adjust handle tube in a comfortable position and
engage the handle release lever by pushing it down until the handle clamp does not slide over the
handle lock.
3.
Slide Switch lock to the right side, press the starting switch on the handle grip. The motor will start.
WARNING:
The chassis should be parallel to the floor when you turn the machine on. If the machine
is not leveled, it will move to one side. It is recommended to familiarize with the machine by working
on large spaces until you gain experience with the machine.
The cable hook can be placed according to desired height and position with the Allen screws.
4.
To turn the machine off simply release the starting switch while keeping hands on handle grip.
5.
Remove driver and brush before storing the floor machine.
* BRUSHES : Wash with warm soapy water. Never use hot water.
Shake and let dry over paper towels with bristles facing down.
Never dry with a heater or blow-dryer, this would deform or let some bristles lose.
* DRIVER :
Wash with warm soapy water. Never use hot water.
Shake and let dry over paper towels.
Never dry with a heater or blow-dryer, this would deform or let some bristles lose.
1. You can find a switch to change the speed of the machine, on the upper cover of the motor (100). The lever
of this switch has two positions. Set the lever to the correct position according to the speed at which you
want to operate the machine.
2. IMPORTANT: Do not change the speed when the motor is working. Change speeds ONLY when the motor is OFF.
* FOR SCRUBBING, USE THE LOW SPEED ONLY (or equivalent wording)
HOW TO START YOUR FLOOR MACHINE
HOW TO ASSEMBLE THE DRIVE PLATE OR BRUSHES
HOW TO CLEAN DRIVER AND BRUSHES
HOW TO CHANGE SPEED (FOR MODEL TP-2S-2015-DC ONLY)
LOW
SPEED
HIGH
SPEED
5