INDEX
I.-OPERATION SISTEM..................................................................................................Page 2
II.-REPLACEMENT PROCEDURES.............................................................................. Page 2 to 3
III.-FAILURE AND SOLUTIONS......................................................................................Page 4
IV.-EXPLOSIVE VACUUM...............................................................................................Page 5
V.-VACUUM CLEANER PARTS LIST............................................................................. Page 6
VI.-TANK ASSEMBLY......................................................................................................Page 7
VII.-DEPOSIT PARTS LIST..............................................................................................Page 8
VIII.-ACCESORIES...........................................................................................................Page 9
IX.-ACCESORIES PARTS LIST........................................................................................Page 10
X.-ELECTRIC DIAGRAM..................................................................................................Page 11
I.-OPERATION SISTEM.
MODEL
Volts
Watts
Hz.
AG-1200
12O ~
1200
60
a).- Motor must work without vibrations
b).- The carbon brushes spark should be small and uniform and the commutor must have dark brown
strip and uniform
II.- REPLACEMENT PROCEDURES
1.- TO REAPLACE THE COVER (4)
1.1.- Remove the filter's unit water (33)
1.2.- Remove the screws located under the body base (13)
1.3.- Replace the new cover, reassemble it was inittially placed
2.-TO REPLACE THE POWER CONTROL (2)
2.1.- Follow steps 1.1 to 1.2
2.2.- Disconect cord reel of electric panel
2.3.- Remove two screws these hold the handle cover top (1) and under the base(3) reassemble both
handle to remove the power control (2)
2.4.- Remove and replace the power control, reassemble it was inittially placed
3.- TO REPLACE THE MOTOR
3.1.- Follow steps 1.1 and 1.2
3.2.- Disconect the harnes (4) terminal's motor and terminal's line cord
3.3.- Remove the four screws holding the motor, release one more located under the cover, and in turn
remuved engine assembly
3.4.- Remove the four screws hold front part motor (30) and release the same
3.5.- Remove the ring's motor(29) Motor Gasket-Rear (23) Motor Gasket-Front (25) and Motor (24)
3.6.- Replace the motor; placed Gasket-Front (25) and rear (23) motor,(24) placing all assembled in the rear
motor (26)
3.7.- place motor bearing ring(29) make sure to respect the positions of the ring on back tap's motor
NOTE: IF YOU DON'T FOLLOW THIS STEPS, YOU CAN'T PLACE THE ENGINE FRONT COVER
3.8.- Reassemble it was initially placed
2/12 Elaborated August 2013.
