Kobelt 5022-H, Руководство владельца по эксплуатации, установке и техническому обслуживанию

Страница: 5 / 29

KOBELT MANUFACTURING CO. LTD MNL-5022-H.docx (rev A) 5
1.2.2 Safety Instructions
Notice to Installer:
Disregarding the following safety measures can result in an accident causing severe injury to
personnel and damage to material assets:
•
Only use the product as directed in this manual.
•
Never put the product into service if there is evidence of visible damage.
•
Never put the product into service before fully completing installation and
commissioning.
•
Do not carry out any modifications to the product.
•
Only use authentic Kobelt spare parts.
•
Observe all local regulations, directives and laws during the installation of this product.
•
All installation, commissioning and maintenance work must only be conducted by
qualified personnel. (For the purpose of this manual, qualified personnel are persons
who are familiar with the assembly, installation, commissioning, and operation of the
product and who have the qualifications necessary for their occupation.)
•
Observe all specifications in this manual. If these guidelines are not followed and
damage occurs, the warranty will be voided.
1.2.3 Hazards
Equipment Starts Automatically:
Brake systems frequently are controlled remotely and may activate suddenly
causing bodily harm. Ensure all power sources are locked out prior to
performing work.
Brake Actuators Contain Compressed Springs:
The brake actuators contain springs that are under compression even when
the brakes are not pressurized. The springs will release suddenly if
disassembled incorrectly posing a risk of serious injury or death. Do not
attempt to disassemble the actuators without clear work instructions and
training.
Pinch Points:
Brakes contain numerous pinch points which can cause serious injury.
Ensure all power sources are locked out prior to performing work.
High Pressure Fluids:
Kobelt lever brakes use high pressure hydraulics. Ensure all pressure is
exhausted and the pressure source locked out prior to performing work.
Hot Surfaces:
Disc brakes are capable of making the surfaces of the brake disc dangerously
hot when burnishing or during braking events. Ensure the disc is adequately
guarded to prevent inadvertent contact with the disc.