KOBE OVS-RAX9430SQB-40, Инструкция по установке и руководство по эксплуатации

Страница: 9 / 21

6
Wiring to Power Supply
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND
LOCAL ELECTRICAL CODES. BEFORE
CONNECTING WIRES, SWITCH POWER OFF
AT SERVICE PANEL AND LOCK SERVICE
PANEL TO PREVENT
POWER FROM BEING
SWITCHED ON ACCIDENTALLY.
-
If hood is operating normally, connect three
wires (black, white and green) to house wires
and cap with wire connectors.
-
Store wires in the wiring box.
Ductwork Installation
3. Use steel pipe to connect the exhaust on the
hood to the ductwork. Use duct tape to make
all joints secure and air tight.
Duct Cover Installation
4. Mark the position of the Duct Cover-Mounting
Bracket {G}. Use reference E from Table 1
and measurements on page 10-11. Attach
and secure Duct Cover-Mounting Bracket {G}
with two screws (not provided). Refer to
Figure 4. NOTE: Inner duct cover will cover
the Duct Cover-Mounting Bracket.
5. Position the entire duct cover up onto the
hood.
6. Secure the inner duct cover with
two (3/16” x
3/8”) screws {H} to the Duct Cover-Mounting
Bracket {G}. Shown in Figure 5.
7.
Secure the outer duct cover with four (3/16” x
3/8”) screws {H} to the Hood Mounting
Bracket.
Install / Uninstall Accessories
8. Place baffle filters underneath the hood.
(Figure 6)
Final Assembly
9. Turn power ON in control panel. Check all
lights and fan operation.
10. Leave this Installation Instructions and
Operation Manual for the homeowner.
Figure 4
Figure 5
Figure 6
Attach Together