KOBE IS2336SQB-1, Инструкция по установке и руководство по эксплуатации

Страница: 8 / 24

Preparations of Ductwork and Location
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT
OPENING.
- Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1.
- A straight, short venting run will allow the hood to perform more efficiently.
- Try to avoid as many transitions, elbows, and long run as possible. This may reduce the
performance of the hood.
-
Use duct tape to seal the joints between pipe sections.
Figure 1
Telescopic Stack Installation
Note: Duct cover with telescopic stack sold separately.
1.
Mark centerlines of cook top or range on ceiling above. Use centerlines marked on ceiling to
position the mounting template as shown in Figure 2.
2.
Remove and save template. Cut and remove ceiling drywall. Install 2” x 4” cross framing lumber
(not provided) between ceiling joists. Refer to Figure 3. Consult a professional if you have
difficulty or your installation is unique.
3.
Finish the ceiling surface. Be sure to mark the location of the ceiling joists and cross framing, or
replace the mounting template in the position of the ceiling joists & cross framing.
4.
Attach the telescopic stack to the ceiling and securely fasten to the joists and cross framing with
eight screws (not provided) as shown in Figure 3. Make sure screws are driven into center of
joists and cross framing for maximum support.
5.
Adjust the telescopic stack using reference F calculated in Table 1 and measurements on page
15-16. Tighten from the side with eight (4x8 mm) screws (provided) as shown in Figure 4.
7