7
SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING SWITCHED ON ACCIDENTALLY.
14.
Connect electrical wires.
15.
Connect three wires (black, white and green) to house wires
and cap with wire connectors. Connect wires corresponding
to their colors (i.e. black to black, white to white, and green to
green).
16.
Store wires in a wiring box.
Hood Installation
NOTE: USE HAND TOOLS ONLY. DO NOT OVER TIGHTEN
SCREWS, MAY CAUSE DAMAGE TO THE HOOD.
17. Remove the light panel by removing 10 screws located at the
bottom of the hood (Refer to Figure 11). Carefully remove the
light support panel.
18. Position the hood inside the custom wood frame, and secure
the hood to the front and rear stud support ( Refer to Figure 2)
by using the front and rear mounting holes (Screws not
included).
19. For a more secure installation, use the mounting holes located
on the side of the hood
20. Make sure hood is secure before releasing.
21. Re-install the light support panel. (Do not over tighten screws.)
CAUTION
: MAKE SURE HOOD IS SECURE BEFORE
RELEASING
Figure 9
Figure 10
Figure 11