KOBE IN2636SQB-700-1, Инструкция по установке и руководство по эксплуатации

Страница: 10 / 24

7
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE
PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE WITH ALL
APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES.
BEFORE CONNECTING WIRES, SWITCH POWER OFF AT
SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING SWITCHED ON ACCIDENTALLY.
14. Connect electrical wires.
15.
Connect three wires (black, white and green) to house wires
and cap with wire connectors. Connect wires corresponding to
their colors (i.e. black to black, white to white, and green to
green).
16.
Store wires in a wiring box.
Hood Installation
NOTE: USE HAND TOOLS ONLY. DO NOT OVER TIGHTEN
SCREWS, MAY CAUSE DAMAGE TO THE HOOD.
17. Remove the light panel by removing 10 screws located at the
bottom of the hood (Refer to Figure 11). Carefully remove the
light support panel.
18. Position the hood inside the custom wood frame, and secure the
hood to the front and rear stud support ( Refer to Figure 2) by
using the front and rear mounting holes (Screws included).
19. For a more secure installation, use the mounting holes located
on the side of the hood
20. Make sure hood is secure before releasing.
21. Re-install the light support panel. (Do not over tighten screws.)
CAUTION
: MAKE SURE HOOD IS SECURE BEFORE
RELEASING
Figure 9
Figure 10
Figure 11
*Note: Sample image only. May not be actual model.
*Note: Sample image only. May not be actual model.