KOBE CH0030SQB, Инструкция по установке и руководство по эксплуатации

Страница: 9 / 28

7
Ductwork Installation
6. Use aluminum or steel pipe to connect
the plastic exhaust on the hood to the
ductwork above. Use duct tape to make
all joints secure and air tight as shown
on Figure 4.
7. To convert ductwork to 7” round,
attached 7” round adapter (provided) to
the 6” round plastic exhaust.
8. For 48” hood, prepare either separate
parallel connection or upside down Y-
connection for proper ductwork
installation. Refer to Figure 5.
Wiring to Power Supply
SA FETY W A RN IN G
RISK OF ELECTRICAL SHOCK. THIS
RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE
BY SPECIALIZED ELECTRICIAN IN
ACCORDANCE WITH ALL APPLICABLE
NATIONAL AND LOCAL ELECTRICAL
CODES. BEFORE CONNECTING WIRES,
SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT
POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
9. Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with
wire connectors. Connect according
to color: black to black, white to white,
and green to green as shown on
Figure 6.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire
connections underneath the hood.
Make sure wires do not slip between
motor or any moving parts to prevent
any damage.
Install Accessories
10. Refer to Figure 7  Slide the baffle filter
into the hood.  Push the baffle filter
upward.  Slide forward.  Pull
downward.  Fit into place.
11. For bottom casing, repeat above steps.
Refer to page 15.
Final Assembly
12. Turn power ON in control panel. Check
all lights and fan operation.
Figure 5
Figure 6
Figure 7