koban KDP-DALI 01, Руководство пользователя, Страница: 97 / 104

Under unlocked status, by pressing " " or " " button firstly to
select desired channel for value setting, then press " " to select
auto or semi-auto mode. If press " " button directly without
selecting one channel, both DA1 and DA2 can select auto or
semi-auto mode simultaneously.
The first time pressing the " " button, LED will flash quickly for
2 sec. to indicate detector entering into Auto mode. Press " "
button one more time, LED will keep on 2 sec. to indicate
detector entering into Semi-auto mode.
KDP-DALI 01
Presence detector for DALi lighting control
45 Instructions manual | www.grupotemper.com
Ex-changing auto mode and semi auto mode
Button Function
•
•
Actual ambient light level can be read-in as threshold for
switching the connected load, if the provided Lux values do not
match user's requirement.
The steps are as below: Press " " button till detector's red
LED flashing to enter into learning mode, learning time is 10sec.
Then the actual ambient light level is read-in confirmed by both
load and LED turn on for 5sec to indicate IR-11DALI learning
successfully and then turn off. Afterwards, it returns to Auto
mode.
Note: If the ambient light level is out of the range of 10 -
2000Lux, detector will learn for 10sec, then LED flashes quickly
for 5sec, and the alternative of 10Lux or 2000Lux value will be
stored depending on under 10Lux or above 2000Lux value.
" " is only valid for DA1 setting.
To read-in the actual ambient light level
•
•
Under unlock mode, press " " or " " firstly to select desired
channel for value setting. Then, press corresponding button to
selected light level threshold is set to presence detector for
switching on the connected load.
Users can set the desired Lux value through pressing " "
button.
To adjust Lux value
To reset settings on presence detector
•
•
By pressing " " button aiming to the detector, all
settings on presence detector will go back to
potentiometers′ settings.
~