13
OPERATING INSTRUCTIONS
a. Remove the battery pack.
b. Use a metal rod (EE) to fix the blade.
3. To replace the blade
If the blade worn out, replace it with a new one (not
provided) produced by Kobalt.
c. Remove the nut by turning it counterclockwise with
the wrench (DD) provided.
d. Remove the washer.
e. Remove the old blade and replace it with a new one.
f. Place the washer on the blade.
g. Place the screw on the washer and tighten it
counterclockwise with the wrench provided.
Nut
Washer
Hardware Used
Wrench
x 1
DD
Metal rod
x 1
EE
DD
EE
Edger Tips
WARNING
Always hold the edger away from the body keeping clearance between your body and the edger.
Any contact with the edger cutting head while operating can result in serious personal injury.
• Hold the edger with your right hand on the rear
handle and your left hand on the front handle.
Keep a firm grip with both hands while in operation.
•
•
•
Edger should be held at a comfortable position with
the rear handle about hip height.
The edger will edge along sidewalks, driveways,
flower beds, curbs, and similar areas.
•
Cut at a steady pace. If the blade begins to bog down,
you are edging too fast; slow your pace. Do not
force the blade into ground.
•
Light contact of the blade against the sidewalk edge,
curb, etc., is acceptable and will not damage the edger.
•
Best appearance is obtained when grass is dry.
Avoid edging in wet soil or wet grass areas or the
blade guard might clog and result in an uneven
edge. If the blade guard becomes clogged, stop
the edger, remove the battery, and remove
debris from the blade guard.
Loosen
Tighten
DD
