Spec
Sheet
Fuel
Conveyance
System
Fuel
Replenishment
System
Köb Holzheizsysteme GmbH, Flotzbachstr. 33, A-6922 Wolfurt, Tel. +43/5574/6770-0, Fax 65707, E-Mail: [email protected]
Subject to technical changes
8160-1
2009-03-01_GB
Silo Feed Auger FS 300 per m
[Art. No. FS-L / 7387808]
Function:
A conveyor auger with an open design for filling fuel storage units situated inside a building from a heap situated outside.
At least two silo feed augers are usually necessary to do this. The silo feed augers are passed through the fuel storage
unit in a manner that achieves the largest possible degree of filling.
Scope of delivery:
-
Silo feed auger as per ordering data
-
Brackets for wall mounting
-
Shaft for wall opening
Note: Auger length with drive unit of max. 10 m
Note on pricing: price specified per m: total length = interior of wall to the end of the auger in the drop-off zone (silo lid)
Only for Pyrot and Pyrtec. For Pyromat-DYN a special design is required.
Drive for silo feed auger ECO
[Art. No. FS-1 / 7388012]
Drive for silo feed auger PYR
[Art. No. FS-2 / 7387898]
Function:
The drive is situated inside the building outside the fuel storage unit, thus producing a pulling effect by the silo feed
auger.
For safety reasons, the key-operated pushbutton has to be placed near the heap. This is done in a manner such that the
operator has to continuously observe the filling process from the outside. Releasing the button immediately stops the
augers.
Scope of delivery:
-
Drive unit for the silo feed auger
-
Spur wheel back-geared motor geared to torque and conveying capacity, 3 x 400V
-
Triggering system for the auger drive appropriate for the boiler control system
-
Key-operated pushbutton ON/OFF for customer-installed closing cylinder (installation near lid).
Note: Only for PYROT and PYRTEC. For PYROMAT-DYN a special design is required.