KNX Iddero Verso, Руководство пользователя

Страница: 50 / 103

This section allows configuration of the Favorites page layout, and access control for the Fa-
vorites and Edit Favorites page.
3.3.7 Touch gestures
Parameter name Values
Gesture: Up
Disabled
/ Send binary value / Run scene
Value to send
(Only for “Send binary value”)
0 /
1
Scene type
(Only for “Run scene”)
External
/ Internal
Scene number
(Only for “Run scene”)
1 ... 64
Gesture: Down
Same parameters as for Gesture: Up
Gesture: Left
Same parameters as for Gesture: Up
Gesture: Right Same parameters as for Gesture: Up
Gesture: Multitouch
Same parameters as for Gesture: Up
Configuration of touch gestures is carried out in this section (see 2.1.10 Touch gestures on
page 20). A different action can be configured for each of the five supported touch gestures.
This can be either sending a binary value to the bus (“0” or “1”), or triggering a scene.
If a binary action is configured, a communication object (
Gesture: Up
,
Gesture: Down
,
Gesture:
Left
,
Gesture: Right
, or
Gesture: Multitouch
) will be enabled. The selected value (
Value to send
)
will be written to this communication object.
If a scene action is configured, this can be either an external scene or an internal scene. For
external scenes, a scene recall request will be sent through the
Run/save external scenes
object.
For internal scenes, the selected scene will be run directly.
Note
If an internal scene shall be run, make sure to enable and configure the “Internal scenes”
function (see
3.2.1 General on page 44 and 3.7 Scenes on page 94).
3.3 User Interface
50