2.1.9
Power saving mode
After a certain period of inactivity (no user interaction), the device will automatically return
to the Home page. Once on the Home page, and again after a certain period of inactivity, the
device enters power saving mode.
During power saving mode, the display is automatically turned off and power consumption is
minimized, even though all functions (such as time schedules, alarm monitoring, etc.) remain
operational.
Both of these inactivity timeouts can be adjusted by the end user through the “Power saving”
option of the Preferences page, or even disabled altogether.
Note
Disabling the power saving timeout is
not recommended
for normal operation, since
this may adversely impact the expected display lifetime.
Touching the screen automatically exits power saving mode. It is also possible to configure
which page will be shown at this point: Either the Home page or the “default page” defined in
the ETS configuration.
2.1.10
Touch gestures
Iddero Verso supports the use of touch gestures for quickly executing up to five preconfigured
actions. Touch gestures can be used while the device is in power saving mode, and also in the
Home screen. The following gestures are detected:
• Swipe up
• Swipe down
• Swipe left
• Swipe right
• Multitouch gesture (touch the screen with more than one finger)
2.1
Visualisation
20
