ASSEMBLY INSTRUCTIONS
Fit the 4 walls and
floor together. The foor-
boards are pointed front-
to-back (not side-to-
side). Glue and hold in
place with rubber bands
until dry.
Glue the roof truss to
the underside of the roof
pieces. Note: the back
edge of the roof has un-
even shingles and the
front has a totally flat
edge.
You may want to use a
quick-setting glue since
the angles make clamp-
ing difficult. Just be
careful not to get glue
on the etched details
(your sticky fingers can
be the culprit, by the
way).
Work on the porch as-
sembly separately. There
are two rails and four
cross-braces. The middle
two cross-braces have
short pegs on one end to
connect to the building,
and long pegs on the oth-
er to form a stair-step.
When gluing the frame-
work to the surface of
the porch, line up the
back edge so the pegs
that connect it to the
building are sticking out.
Glue the porch to the
building, using glue not
only on the pegs, but al-
so on the back edge of
the boardwalk piece.
As you can see from the
rear-view photo at left,
the back porch steps fol-
low the same logic. The
short pegs go in the
building, and the stairs
are glued to the top sur-
faces of the stair frame
pieces.
Porch posts are arranged
as shown at left. The
pieces on each end have
an additional leg which
rests against the front of
the building and acts as a
corner trim piece. The
middle two posts are “L”
shaped.
Содержание GUNFIGHTER'S BALL HARDWARE STORE
Страница 1: ...INSTRUCTIONS...
