OPE-ESYSLR-0338-B
©Knox Company. All Rights Reserved
KNOX ELOCK CORE RETROFIT:
KLS-1500 KNOX HOMEBOX INSTALLATION GUIDE
4
1601 W. DEER VALLEY RD. PHOENIX, AZ 85027 |
T.
800-552-5669 |
F.
623-687-2290 | [email protected] |
KNOXBOX.COM
This concludes the Knox eLock Core Retrofit Instructions.
Installation of the Knox RainGuard
™
:
Use a sharp instrument to remove the
adhesive backing from the bottom half of
the Knox RainGuard. The bottom half is
the section with the open circle.
12
Use the provided alcohol wipe to clean
the backside of the Dust Cover and the
surface area all around the Lock
(see note
below regarding Dust Cover Magnet)
.
11
NOTE:
Use a flat head screwdriver to remove
the Dust Cover Magnet.
Mount the Knox RainGuard to the
Dust Cover Bracket. The Knox
RainGuard’s open circle will fit tightly
around the Lock Shell.
13
Using the nose of the foam as a
guide, fold the upper half of the Knox
RainGuard to align with the Lock Core
center. The nose will fold over and into
the Lock Core for protection.
14
Remove the adhesive backing from the
back side of the Knox RainGuard's upper
half. Pull out and close the Dust Cover
with pressure allowing the Knox RainGuard
to firmly attach to the Dust Cover. Lift the
Dust Cover up and press both halves of
the Knox RainGuard for a firm fit.
15
Lastly, remove the adhesive backing
from the Knox "K" reflective label, and
place front and center of the Dust Cover.
15
Use a flathead screw driver to remove the
Dust Cover Magnet from the Dust Cover
Bracket.
10