INTERCONNECTION DIAGRAM
7
1
Welder
1 set
2
Operator’s Manual
1 pc
3
Electrode Holder
1 pc
No.
Description
Qty.
TRANSPORTATION AND STORAGE
NOTES: All above mentioned are based on the ordering contact unless otherwise agreed by the parties.
• This machine is an indoor equipment and the attacks of
rain and snow should be avoided in the process of
transportation and storage. While loading and unloading,
more attention should be paid on the package with words
of warning. Storage warehouse should be kept dry with
good air circulation and no corrosive gas or dust.
The temperature should be maintained from -25º C to 55º C
and relative humidity must be lower than 90%.
• If the products are still needed to continue storing after
stripping, repacking should be carried out according to
original package’s requirement. Remember before storage,
don’t forget to clean and seal it with plastic bags.
• Users should maintain the cartons and shock blocks in order
to be properly packaged in need of long distant transportation.
For the long distant transportation, it should be retrofitted
with a wooden case and mark the “up” or “rain” symbols.
4
Earth Clamp
1 pc
5
Face Mask with Filter
1 pc
6
Brush & Hammer
1 pc
No.
Description
Qty.
ACCESSORIES
min
32
50
62
96
max
40
60
75
128
1.6 mm
2.0 mm
2.5 mm
3.2 mm
1/16”
5/64”
3/32”
1/8”
ROD DIAMETER
Amperage ratio according to electrode diameter
(Approximate value)
Note:
The table is only informative, it does not mean that the
equipment can operate all the listed electrodes and diameters,
only those that the amperage and duty cycles allow.
JOB SUGGESTION
min
120
200
256
max
160
250
320
4.0 mm
5.0 mm
6.4 mm
5/32”
3/16”
1/4”
ROD DIAMETER
ECN Soldering Iron
Circuit Schematic
(Reference figures
are subject to change
without notice).
