KNOVA KN GEN-16, Руководство пользователя

Страница: 7 / 24

6
OPERATION METHOD
Connect to load
Access electric equipment
and turn the circuit breaker
to ON. Please note that
when several loads are used
at the same time, do not
access the next one uniess
the former one is running
normally. The total power of
the loads should not exceed
the rated power of the unit.
Disconnect load
Disconnect the electric
equipment from the control
panel of the generator.
SHOT DOWN
Turn off the engine switch
Turn the engine switch to
OFF.
OFF
Turn off the fuel valve lever
Turn off the fuel valve lever
after the shutdown of the unit.
The
surface temperature
of the generator unit is still
high after shutdown, and it
can not be moved or operated
before cooling down in order
to avoid scalding.
WARNING
OFF
Drain the fuel
Remove the oil draining bolt
of the carburetor and drain
the fuel from the fuel tank
and carburetor. then tighten
the oil draining bolt again (if
the fuel is not drained, the
fuel will evaporate and flow
into the air, and the residues
may block the carburetor).
It may be causing the dangers of injury
by the sudden change of rotation direction of the
engine during operating the recoil starter.
WARNING
Open the choke valve
After starting, let the unit
run without load for
30 seconds and then turn
on the choke valve switch.
WAIT
30 sec
Protective treatment
The unit should be stored in
a clean and dry place and
should be protected from
rain and high temperature.
Shield the unit with paper
box or plastic bag to prevent
dust from entering the unit.