KNOVA KN DP-2500N, Руководство пользователя, Страница: 9 / 40

8
ASSEMBLY AND ADJUSTMENTS
INSTALLING THE HEAD (FIG. G)
W A R N I N G
The Drill Press head is heavy and should
be lifted with the help of two PEOPLE
OR MORE to safely assemble the drill press head on the
column.
1. Carefully lift the head (1) and slide it into the column (2).
Make sure the head slides down over the column as far as
possible. Align the head with the base.
2. Using the 4mm hex wrench provided, tighten the two head
locking setscrews (3) on the right side of the head.
INSTALLING FEED HANDLES (FIG. H)
1. Thread each feed handle (1) into the threaded holes (2)
on the hub assembly (3) and Tighten.
INSTALLING THE CHUCK (FIG. I, J AND K)
1. Clean out the tapered hole in the chuck (1) with a clean
cloth and a non-alcohol based cleaner. Wipe clean all oil
reside and any dirt or grime thoroughly.
2. Clean tapered surfaces on the spindle
(2) in the same manner as above.
3. Open the jaws of the chuck (1) by
rotating the chuck sleeve clockwise.
To prevent damage, make sure the
jaws are completely receded into
the chuck.
NOTE: Make sure there are no foreign
particles sticking to the surfaces. The
slightest piece of dirt or oil reside on
any of these surfaces will prevent the
chuck from seating properly. This will
cause the drill chuck and bit to wobble.
If tapered hole is extremely dirty, use
a non-alcohol based cleaner on a clean
rag to clean.
4. Unlock the table support lock (4- Fig. D) and swing the
table away from the bottom of the chuck.
5. Using a rubber mallet or a hammer and a block of wood,
tap the chuck onto the spindle firmly (Fig. K).
Fig. F
10
9
11
12
Fig. G
2
3
1
Fig. H
1
2
3
Fig. I
2
1
Fig. J
3
2
1