© Knoll, Inc.
2 of 9
Step 1. Adjust the width of the frame assembly.
D — Foot x2
A — Frame End x2
I —Machine Screw x8
M— Worksurface
F — Programmable
Digita Handset
J— Countersunk
Screw x8
B — Crossbar
(Pre-Installed)
C — Lifting Column x2
G — Leg Cable
L —Set Screws (Pre-In-
stalled) x4
O — Hex
Wrench
H — Power Cable
K — Wood Screw x14
A — Frame End x2
B — Crossbar
(Pre-Installed)
1
2
3
4
M
Hardware
Phillips Screw Driver or Drill
NO IMPACT DRIVERS
(Not Included)
Tools
+ Washers ship with the base and are
installed between screw head and
worksurface. See step 3.
+ Cable management sticky pads are also
included. They should be added here.
+
Installation Note: Screwing through the pad
(rather than relying on the double stick tape,
which can fall off) is recommended.
E — Control Box
Standard Electric or
Extended Electric
