Knoll HDP410, Руководство пользователя

Страница: 21 / 30

21
When Autosource is not checked, the projector defaults to Component initially, then defaults to
whatever the last active source was when the projector was powered down. To display another
source, you must manually select one by pressing the
Source button on the remote or keypad.
This cycles through all the sources that are selected in the Source Enable menu.
The Source 1, 2, and 3 menus in the Sources menu allow
Sources Source Enable
you to assign a source to the Source 1, 2, and 3 buttons
on the remote. The Source 4 menu selection would
apply to the Custom key if that option is chosen in the
Custom key menu, see page 22.
To use the SCART RGB source, you must first select
it in the Source Enable menu (the projector cannot
automatically detect this source). Enabling
SCART will disable Component and Composite
sources.
System>OSD Offset
: System>OSD Offset: allows you to adjust the
position of the OSD. By default, the menus are postponed in the
upper left hand corner of the displayed image and the messages are
postponed in the lower left hand corner. Adjust the offset to move
these items more to the right and middle of the display.
Rear: reverses the image so you can project from behind a
translucent screen.
Ceiling : turns the image upside down for ceiling-mounted projection.
Auto Ceiling: uses an internal sensor to automatically turn
on ceiling mount mode if the projector is inverted.
High Power : maximizes the light output of the lamp.
Auto Power : when AutoPower is checked, the projector automatically goes into the startup state
after the projector receives power. This allows control of ceiling mounted projectors with a wall
power switch.
Display Messages : displays status messages (such as “Searching”) in the lower-left corner of
the screen.
Translucent OSD : makes the menus translucent. This prevents the image from being completely
covered by the menus while you are making image adjustments.
Sleep Timer : automatically turns off the projector after 4 hours.
Power Save : automatically turns the lamp off after no signals are detected for 20 minutes. After
10 additional minutes with no signal, the projector powers down. If an active signal is received
before the projector powers down, the image is displayed.
Startup Logo:
allows you to display a blank screen
instead of the default screen at startup.
.
Blank Screen
: determines what color is displayed when
you select Blank Screen in the Startup Logo menu
and when no source is displayed.