DIR21P
DIR21P Digital Infrared Receiver Specifications:
Specifications
Infrared carrier frequency: 30-60kHz
Indoor reception range:
150 feet + (45 )
Outdoor reception range: 35-50 feet (10-15 meters)
Nominal reception angle: 50 degrees off axis
Wire requirements:
three conductor, minimum 24
Gauge to 200’, 22 gauge up to 500’
20 gauge to 1000’
Power requirements:
Unregulated 12VDC, 40mA
Dimensions:
1-3/4" x 4" x 1"
(45mm x 102mm x 26mm)
Requires 12VDC power supply and emitter.
Digital Infrared Receiver
Installation Instructions
v1.1
Warning
: To be installed and/or used in accordance with
appropriate electrical codes and regulations.
Introduction:
Thank you for your purchase of a Knoll
DIR21P digital infrared receiver. This receiver features a long
indoor usable range and it can be used in direct sunlight and
near plasma and other TV’s. It is designed to act as a remote
receiver of remote control signals that when passed through a
connection module and emitters, relays remote infrared
commands to equipment in a distant room. It is very similar to
the DIR21 with an added internal processor, so a connection
block is not needed. A single or dual emitter can be connected
to the DIR21P
Features:
•
Inwall junction box design,
available in white, ivory, almond
and black colors.
Warranty
System
power
on LED
IR
Receiver
Blue
talkback
LED
Knoll Systems warrants its products sold in the USA and Canada by authorized
Knoll dealers to be free of defects in materials and workmanship. This warranty
extends for three full years from the date of purchase by the original consumer.
Any products returned to Knoll Systems and found to be defective by Knoll
Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of
installation or removal of the product, nor for any incidental or consequential
damages. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation may not apply to you. This
warranty gives you specific legal rights. You may have additional legal rights
that vary from state to state.
•
Digital processor included for
direct hook up to emitters
without a connection block.
•
Will relay almost all remote
control types (except some
mod
B & O and Pioneer Elite
•
els).
Wire run can be 1000’ (300m)
ery little power.
or more
Requires v
•
Suggest using Knoll PS1202 12 vdc.
Knoll Systems www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
12140 Horseshoe Way Richmond BC V7A 4V4
tel (604) 272 4555, fax (604) 272 5595
Made in Canada Knoll Systems All Rights Reserved