6K Rear Panel
12V trigger
3
4
L
R
3L+
3L 3R 4L 4R
Gain
Inputs
Outputs
3L-
4L-
4L+
3R+
3R-
4R-
4R+
1
2
L
R
1L+
1L 1R 2L 2R
Gain
Inputs
Outputs
1L-
2L-
2L+
1R+
1R-
2R-
2R+
5
6
L
R
5L+
5L 5R 6L 6R
Gain
Inputs
Outputs
5L-
6L-
6L+
5R+
5R-
6R-
6R+
Link-Out
Link-Out
Link-Out
Link-Out
Link-Out
Link (out position)
cascades channel 1
to channels 2-6
Note 1: Ideal speaker
impedance is 6-8 ohms.
Caution: NEVER connect the
4K or 6K to impedances less
than 4 ohms or amplifier
damage not covered by the
warranty may occur.
Trigger is 12 VDC (35mA per 4K and/or 6K) via 3.5mm mono jack.
5 VDC trigger outputs will not work.
To connect the trigger to a receiver switched outlet use a 12 VDC
power supply (we suggest Knöll PS1202 power supply). Plug the power
supply into the switched outlet on the rear of the receiver. Connect
the 12 volt wire to a 3.5mm mono jack. Plug the jack into the rear
of the 4K or 6K. 12 VDC polarity is not important.
When the receiver is switched on, the 4K and/or 6K amplifier is
switched on.
12345
12345
12345
12345
12345
12345
12345
AC120V
8 amps
The Link button is normally set to the in position to
give all six stereo inputs individual sources. When the
Link button is set to the out position, that input Left/
Right is linked or cascaded to input #1 (without the use
of Y cords). Any or all combination of linked inputs 2
to inputs 6 are possible. When all inputs are linked to
input 1 the input impedance is about 8500 ohms.
Note: When linked unused RCA inputs can be used as
outputs to other amplifiers
