2
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following product:
EMTWINIP
GENERAL INSTRUCTIONS
SAFETY
INSTALLATION
• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current building regulations. If in any doubt, please consult a qualified electrician.
• Please isolate mains prior to installation or maintenance
• Check the total load on the circuit (including when this luminaire is fitted) does not exceed the
rating of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
• This product is Class I and must be earthed
• This product is IP65 rated
• Drill the fixing holes in the rear of the fitting. Mark the location of the fixing holes, and drill
ensuring not to infringe with any gas / water pipes or electrical cables
• Choose a suitable cable entry. 20mm drilling guides are provided on the rear or side of the unit.
Ensure a suitable gland is used to retain the IP rating. Fix the luminaire to the surface using
appropriate fixings
• Connect the luminaire to the mains supply (via the terminal connector) ensuring the correct
polarity is observed (see Fig 2). Live (brown), Neutral (blue) and Earth (green and yellow)
• Provide power to the required point of installation. Suitable IP rated junction boxes should be
used where required
• Unscrew the four fastening screws and remove the front cover (see Fig. 1)
Fig. 1
EMTWINIP
These instructions should be read carefully and retained after installation by the end user for future reference and
maintenance.
These instructions should be used to aid installation of the following product:
EMTWINIP
SAFETY
•
This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current building regulations. If in any doubt, please consult a qualified electrician.
•
Please isolate mains prior to installation or maintenance
•
Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
•
Please note the IP (Ingress Protection) rating of this luminaire when deciding the location for
installation
•
This product is Class I and must be earthed
•
This product is IP65 rated
•
This product is non-dimmable
INSTALLATION
•
Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
•
Unscrew the four fastening screws and remove the front cover (see Fig. 1)
Fig. 1
•
Drill the fixing holes in the rear of the fitting. Mark the location of the fixing holes, and drill ensuring
not to infringe with any gas / water pipes or electrical cables
•
Choose a suitable cable entry. 20mm drilling guides are provided on the rear or side of the unit.
Ensure to use a suitable cable gland to retain the IP rating. Fix the luminaire to the surface using
appropriate fixings
•
Connect the luminaire to the mains supply (via the terminal connector) ensuring the correct polarity
is observed (see Fig 2). Live (brown), Neutral (blue) and Earth (green and yellow)
•
Connect the battery to the battery connector on the PCB (see Fig. 2)
Unscrew