Page 6 of 12
0901225 Rev: X6 (draft 10/09/20)
PRE
-
RELEASE COPY
--
NOT FOR DISTRIBUTION
Figure
H
Figure
D
(3)
[Fig. D] Plug power cord into a suitable power source.
WARNING: See page 2 for important safety
instructions and proper grounding practices.
(4)
[Fig. E] Turn main power switch on base unit ON.
(5)
[Fig. F & G] Press green rocker switch on spray
nozzle to the ON position, then hold down PRIME
button for about 25 seconds to prime the fluid pump.
If the spray pattern is choppy or uneven, continue
priming for about 10 seconds longer until the spray
begins to flow smoothly.
NOTE: Point the spray nozzle into an open area while
priming to avoid wetting an unintended surface.
WARNING: Do not touch the tip of the sprayer
when in use.
(6)
[Fig. H] Point nozzle toward surface to be sprayed
and slowly move nozzle in a back and forth motion
until the surface is satisfactorily covered with an even
coating. Use a clean cloth to wipe excess chemical
deposits that may buildup on the sprayer gun due to
blowback during operation.
NOTE: For complete wrapping coverage of the
sprayed solution, press the CHARGE button on the
back panel to the ON position [Fig I]. Unit can be
operated with charge feature off if wrapping is not
needed, for example a large flat surface.
(7)
[Fig. F] Turn sprayer off by pressing rocker switch on
spray nozzle to OFF position.
Figure
G
Figure
E
Figure
F
Figure
I
