0900511 Rev: E (06/05)
Page 9 of 20
•
Change dispenser ID #
•
Change main access code
•
Set date and time
•
Set unit of measure
•
Set flush time and sampling delay
•
Set simultaneous pump operation
•
Set number of users
*** DISPENSER ***
SETUP ROUTINES
2
This menu selection allows you to change the dispenser ID
number. The dispenser ID number has two purposes:
(1) It is printed in the upper-left corner of reports to identify which
dispenser the report came from. This can be helpful when more
than one dispenser is installed at the location.
(2) When running ILCS WinReporter software (optional), the ID
number is used for “logging on” to the dispenser from the
computer. Several dispensers can be connected together in a
daisy chain format known as “multilinking”.
Press YES to invoke the command, or press NO to move on to
the next menu selection. If the ID number is changed, you must
set the ID of the external memory module in menu #1.
CHANGE DISPENSER ID# ?
PRESS: YES OR NO
NO
YES
GO TO NEXT PAGE
Use the number buttons to enter a 2-digit ID number,
then press ENTER. Press the MENU
button to move
on to the next menu selection.
NEW DISPENSER ID# 00
THEN PRESS ENTER
This menu selection allows you to change the main access code.
Press YES to invoke the command, or press NO to move on to
the next menu selection.
CHANGE MAIN ACCESS CODE ?
PRESS: YES OR NO
NO
YES
Use the number buttons to enter a 3-digit main access
code, then press ENTER. Press the MENU
button to
move on to the next menu selection.
MAIN ACCESS CODE = 000
THEN PRESS ENTER
This menu selection allows you to set the time and date. Press
YES to invoke the command, or press NO to move on to the next
menu selection.
SET DATE & TIME ?
PRESS: YES OR NO
NO
YES
Use number buttons to set date and time (military format,
13:00 = 1:00 PM) then press ENTER. Press the MENU
button to move on to the next menu selection.
HOUR 00 MINUTE 00
MONTH 00 DAY 00 YR 00
