Knight Idex MX PLUS, Инструкция по эксплуатации

Страница: 4 / 12

0901220 Rev: A (final 04/20) Page 4 of 12
CONNECTING MULTIPLE UNITS
•
Multiple units can be connected side by side using the quick connector (7366049) for any configuration that is required.
See Figure 3
•
Water inlet connection can be relocated from right to left side if necessary by following the steps below.
(1) Remove the brass inlet fitting from the right side by turning it counter - clockwise (Figure 4).
(2) Remove the plastic plug from the left side by turning it counter - clockwise.
(3) Insert the brass inlet fitting into the left side by turning it clockwise until hand - tight and the flats are aligned.
(4) Insert the plastic plug into the right side by turning it clockwise until hand - tight and the flats are aligned.
DILUTION DYNAMIC WATER PRESSURE
30 PSI 40 PSI 50 PSI
1 GPM
512:1 P/N 2201221-35 P/N 2201221-30 P/N 2201221-25
4 GPM
512:1 P/N 2201221-05 P/N 2201221-05 P/N 2201221-05
750:1 P/N 2201221-10 P/N 2201221-10 P/N 2201221-10
935:1 P/N 2201221-15 P/N 2201221-15 P/N 2201221-15
1400:1 P/N 2201221-25 P/N 2201221-25 P/N 2201221-25
TORTUOUS PATH METERING DEVICE (TPMD)
Many sink sanitizers and concentrated cleaning products require dilution rates that exceed 250 to 1. For these products, the
TPMD was developed to meter precise amounts of chemical to water without plugging, and with unparalleled accuracy.
Dilution rates range from 250:1 to 1500:1 with the Flex Gap or Aire Gap backflow preventers. The following table will guide
your selection of the TPMD that suits your needs. Tortuous paths metering devices are optional items.
Note: Mixing Ratios should be used for reference only. Ratios and flow rate will vary depending on water pres-
sure, chemical viscosity, and length of chemical lines.
Figure 3
Figure 4