Page 5
Assembly Instructions
knightgroup.co.nz
Page 5
Assembly Instructions
Handset manual
Agile Round Desk
Display
screen
Home
key
Memory
key
Up & down
key
OPERATION
• Up & down key
- Keep touch key to adjust desk height until
you reach optimum height.
• Display screen
- Shows current height of desk
• Memory key
- After setting memory key desk height will
auto adjust to the chosen setting.
• How to set memory key - Adjust desk to preferred height
using up & down key. Touch a memory key for 5 seconds
until you hear a beep to save setting
• Home key
- Auto adjusts desk height to 72cm. This height
is the standard optimum height when sitting.
Handset locks automatically after 30 seconds of no use.
To unlock handset touch up or down key.
ADDITIONAL SETTINGS
Press home key until you hear a second beep.
Use the up and down keys to navigate then press the home
key to make your selection.
A = Sensitivity of downwards anti collision
Up & down keys to navigate to selection
1 - High sensitivity
2 - Standard sensitivity
3 - Low sensitivity
4 - Off
Press M2 to make selection.
Press M2 again to save selection and return home screen.
B = CM or IN display
Up & down keys to navigate to selection
1 - CM
2 - IN
Press M2 to make selection.
Press M2 again to save selection and return home screen.
C = Home height setting
Up & down keys to adjust height
Press M2 to make selection.
Press M2 again to save selection and return home screen.
D = Minimum height setting
Up & down keys to adjust height
Press M2 to make selection.
Press M2 again to save selection and return home screen.
E = Maximum height setting
Up & down keys to adjust height
Press M2 to make selection.
Press M2 again to save selection and return home screen.
F = Sensitivity of upwards anti collision
Up & down keys to navigate to selection
1 - High sensitivity
2 - Standard sensitivity
3 - Low sensitivity
4 - Off
Press M2 to make selection.
Press M2 again to save selection and return home screen.
ERROR CODES
ER1 = Motor stop
Power off and restart. If fault still exists there is a motor problem.
ER2 = Synchro error beyond 15mm
Power off and restart. If handset display RST (down key unlocked)
keep touching down key to the lowest number.
ER3 = Cable fault
Motor cable is off or broken. Power off and restart.
ER4 = Communication fault
Check cables for handset and controller. Power off and restart.
ER5 = Overload protection
There is too much weight on desk. Lighten load, power off and restart.
Hot = Overload power protection
Will auto recover after 5 min.
