Setup Instructions:
Step 1: Install Steering Column
Insert the steering column tiller into the tube at the front of the frame (as
shown in the left photo). Lower the steering column towards the rear by
lifting the clamp lever up to release the clamp from the steering column
and pull the lever forward to disengage (as shown in the right photo).
Push the lever to the left and downward simultaneously to disengage the
security pin and gently guide the steering column downward. Please
ensure that the handle bars are aligned with the wheels before
proceeding.
Next, take the provided allen wrench and tighten the exposed allen screw
- turn clockwise until tight (as shown in upper left photo on opposite
page). Raise the steering column, and again push the lever to the left and
downward simultaneously to allow the security pin to lock into place.
Raise the clamp lever upward and tighten by turning it clockwise. Finally,
push clamp lever down firmly to secure the steering column (as shown in
upper right photo on opposite page). Use the black knob to set the
handlebars at a comfortable height for operation. – typically waist height.
Step 2: Install Knee Platform & Attach Basket
The knee platform is designed to be used with either the right or left leg.
Remove the knee platform from the bottom of the KneeRover
TM
scooter
by removing the locking pin and loosening the clamp. Next insert the
knee platform post into the receptacle tube and set the knee platform at
your desired height for use by inserting the locking pin through the
aligned holes. Finally, tighten the clamp to secure the knee platform in
place. Removable basket attaches to the steering column.
Clamp
Lever
Push Pin to Left
Tiller
Push
Lever
Left to
Release
Security
Pin
Tighten Allen Screw
Locking
Pin
