1
42
1
Figure 7-42
Knife position on the grinding
wheel
Figure 7-43
Adjusting the knife to the center
of the grinding wheel
Turn clamping lever (7-41/1) to “Closed” position.
The knife is now locked.
Swivel the grinding plate with the clamped knife
forward onto the grinding wheel.
7.2.3 Positioning the knife on the grinding wheel
The cutting edge of the knife (7-42/1) must lie
approximately on the center of the grinding
wheel.
To do so, loosen the lower clamping lever (7-43/1)
counterclockwise and move the entire grinding
unit until the cutting edge of the knife is approx-
imately at the center of the grinding wheel (see
Illustration 7-42/1).
Retighten the lower clamping lever (7-43/1).
1
Figure 7-41
Locking the knife on the grinding
plate
7. Operating the HV 203
