DAD 6.1L/DAD 2.1L/MWD 2.1L user manual V6700, version 3.2
Installation
13
Operating Environment
Only if the requirements for ambient conditions of the operating environ-
ment are met, can the intended use be ensured. Details on the operating
conditions can be found in the Technical Data section.
Device defect
The device overheats at exposure to sunlight and insufficient air circulation.
Device failures are very likely.
Set up the device in such a way that it is protected against exposure to
direct sunlight.
Keep at least 15 cm clear at the rear and 5–10 cm at each side for air cir-
culation.
Space Requirements
At least 5 cm if another device is set up on one side
At least 10 cm if further devices are set up on both sides
At least 15 cm on the rear panel for the fan.
Leave the power plug on the rear of the device accessible to be able to
disconnect the device from the mains.
General requirements
Position the device on a level and even surface.
Protect the device against direct exposure to sunlight.
Set up the device at a location not exposed to air drafts (A/C systems).
Do not set up the device in the vicinity of other machines that cause floor
vibrations.
Avoid sources of high frequencies near the device. High-frequency
sources may compromise measuring values.
Earthquake Areas
If you are located in an earthquake area, use the bore holes
1
in the side
panels to secure the device. The bore holes are located on either right or left
side panel.
Setup
Prerequisite
Check packaging for damage caused during transportation. If necessary, put
forward any claim for damages to the carrier.
Tools
Utility knife
Bruising danger
Damage to the device by carrying or lifting it on protruding housing parts.
The device may fall and thus cause injuries.
Lift the device on the side of the housing only.
Fig. 5
bore holes of device
1
