Single Pullout Waste Bin
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
SP-BSC10-1-35-P
Place sliding base assembly on cabinet floor,
in desired position. Position front mounting
strap against the back edge of the cabinet
face frame. (If installing in a frameless
cabinet, measure 1/2" to 3/4" back from
front of cabinet opening, and align sliding
base assembly parallel to cabinet opening.)
Close door to make sure the assembly will
not hold cabinet door open. Also, check to
see if unit will clear the door opening when
fully extended. Once position is determined,
fasten in place using four mounting screws
provided and a Phillips head screwdriver.
Optional Step: Mark placement of
mounting holes with a pencil, remove
sliding base assembly and drill pilot holes
for fastening screws. Place sliding base
assembly back into position and fasten
with the provided screws.
1
Tools Required
• Phillips Head Screwdriver
Product Assemblies
Waste Bin (1)
Wire Cage (1)
Sliding Base Assembly (1)
Cage Locking Clip (1)
Clip-On Handle (1)
Mounting Screws
Parts Included
1
Mounting
Straps Sliding Members
Optional
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil