Use the installation template to locate, mark, and drill the necessary
top and bottom mounting holes.
NOTE: The installation template is designed for marking the top AND
bottom of the Frame (A).
Remove the 2 Pull-out Shelves (B) and 4 Adjustable Side Baskets (C)
from the Frame for fitting Frame (A) into cabinet. To remove the
drawers squeeze the release levers that are located on the bottom
front of the shelf ( Gray in color). Make sure all the slides are pushed
back into the closed position (see A) on the Frame. Place the Frame
into the cabinet. Align the bearing mounting holes to the pre-drilled
mounting holes. Secure with fasteners (Note: It may be necessary to
rotate the Frame in order to locate the pre-drilled mounting holes).
Test the unit for proper rotation. The unit should rotate evenly in
both directions. If the rotation is not even in both directions, then
the bottom bearing is secured in the incorrect position. To correct,
remove the fasteners from the bottom bearing only and rotate the
bearing by one hole in whichever direction is necessary for even
rotation. Reinstall fasteners.
Reinstall the 2 Pull-out shelves. To reinstall the shelves place shelf on
slide and push back. The shelf will be secured by the two pins that
are located on the top of the slides and the release levers will snap
into the slides. Reinstall and position the 4 adjustable side baskets for
intended use.
Full-Round
Lazy Susan Drawer System
Installation Instructions
310103/0907
Inspect all parts and read all instructions prior to beginning assembly and installation.
©2007 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change speci
fi
cations without notice. Made in USA.
2700 Oak Industrial Drive NE
Grand Rapids, MI 49505 USA
800.253.1561 • www.kv.com
1
2
Product Assemblies
SDS-FR-28-CW
Parts Included
A. Frame (1)
B. Pull-out Shelves (2)
C. Adjustable Side Baskets (4)
D. Installation Template (1)
E. Mounting Screws (4)
A
B
C
D
E
Tools Required
• Phillips Screwdriver
• Drill with 1/16" (1.5 mm) bit
• Pencil
template
x (8)
3
