Place sliding base assembly on cabinet floor, in desired position. Position front
Mounting Strap against the back edge of the cabinet face frame. If installing in a
frameless cabinet, measure 1/2
˝
to 3/4
˝
back from front of cabinet opening, and
align sliding base assembly parallel to cabinet opening. Close door to make sure
the assembly will not hold cabinet door open. Also, check to see if unit will clear
the door opening when fully extended. Once position is determined, fasten in
place using four mounting screws provided and a Phillips head screwdriver.
Optional Step:
Mark placement of mounting holes with a pencil, remove sliding base assembly
and drill pilot holes for fastening screws. Place sliding base assembly back into
position and fasten with the provided screws.
If sliding members are fully extended, close unit so that the rear cage clip retainer–
built into the side of the sliding members–are inside the cabinet. Beginning with the
rear-most wire cage, hold the cage over the sliding base assembly so that the
cage aligns with the clip retainer. The orientation of your bins is demonstrated in the
top view chart below. Pushing firmly, lower wire cage into clip retainers until fully
seated. (NOTE: Never install wire cage(s) when slides are extended.) Close unit
completely and install front-most wire cage in the same manner. Insert bins into
cages, place lids on top of bins (if supplied) to complete the installation. If your unit
did not come pre-packed with lids and you would like lids, visit www.kv.com to
purchase the lids you require.
Parts Included
A. Waste Bins (2)
B. Wire Cages (2)
C. Sliding Base Assembly (1)
D. Mounting Screws (4)
E. Lids (if supplied)
Tools Required
• Phillips Head Screwdriver
Optional
• Drill with 1/16
˝
(1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
PSW15-2-20
PSW15-2-35
PRC12-2-27
SLIDING DOUBLE WASTE BINS
Installation Instructions
310163-0609
Inspect all parts and read all instructions prior to
beginning assembly and installation.
2
1
1
2
Top View
A
A
Double Bin
BIN
PSW15-2-20
PSW15-2-35
PRC12-2-27
Overall
Cabinet Width:
15" & 18"
2700 Oak Industrial Drive NE , Grand Rapids, MI 49505 USA
800.253.1561 • 616.459.3311 • www.kv.com
©2009 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change speci
fi
cations without notice. Made in USA.
A
B
D
E
Clip
Retainer
C
Mounting
Straps
Sliding
Members
BIN
