BOTTOM MOUNTING WIRE
KIDNEY LAZY SUSANS
Installation Instructions
KNAPE & VOGT MANUFACTURING COMPANY
P.O. Box 191, Muncie, IN 47308
0.899.6535 • 765.288.8730 • Fax 765.288.0851 • www.kv.com
RN-244EFS 04/03
Inspect all parts and read all instructions prior to beginning assembly and installation.
Parts Included
A. (2) Shelves
B. Post
C. (2) Shaft collars
D. (4) setscrews
E. (4) T-nuts
F. Plastic post cap
G. Mounting screws
Tools Required
• Phillips head Screwdriver
• Drill with 1/16” (1.5mm) bit for drilling
pilot holes
• Pencil
Product Assemblies
PC18S-
Step 1
To locate the unit inside your cabinet, place a
shelf on the post and position it inside the
cabinet so the door can close without
interference. Mark all screw hole locations on
the cabinet floor. Remove the post and shelf
from the cabinet. Drill pilot holes for fastening
screws, and attach the post to the cabinet
floor using the screws provided.
Step 2
Assemble the shaft collars by
placing T-nuts through holes and
inserting setscrew into T-nut. Turn
screw 2 or 3 times to engage. It will
be tightened later. Place one of the
shaft collars (slotted side up) at the
desired height for the lower shelf
and tighten setscrews finger-tight to
hold in place. Position the shelf with
the pie-cut in the front and rotate
the shaft collar to fit the shelf hub.
Tighten the setscrew on the collar
and close the door to check for
clearance.
Step 3
Place the second shaft collar
(slotted side up) on the post and
repeat the installation instructions
above. Insert the plastic cap in
the top of the post and the
installation is complete.
A
B
C
D
E
F
step 1
step 2
step 3
