4.
Holding the middle cabinet member,
push the slide back approximately 1/2"
so that the mounting hole is accessible.
Install 1 – #6 x 1/2" wood screw (4).
5.
Ensure that upright brackets are parallel
to the front of the cabinet then attach to
the base of the cabinet with 4 –
#8 x 3/4" wood screws (5A).
NOTE: Screws can be placed in slotted
holes for future adjustment or in round
holes to ensure the unit does not move.
6.
Push rear slide brackets back until they
are against the back of the cabinet.
Attach to the back of the cabinet with
3 – #6 x 1/2" wood screws per bracket
(5B).
7.
Fully extend slides. Install lower basket
to left hand slides by placing tabs
through the wire basket. Next push
basket into hooks on right hand slides
while supporting the slide member.
Repeat process for upper basket (6).
Installation is now complete.
4
5
5B
5A
6
Left Slide
Right Slide
Align as Shown
