KMR 12100534, Инструкция по эксплуатации

Страница: 7 / 45

EN - 7
Device-specific additional instructions for nailer
.3482
4 Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
•
Check fasteners for proper condition.
•
Turn the tool upside down, press the lock 1 and pull the lower
slide 2 backwards. Release the locking button 1, insert the
clamps 3 into the magazine. Then push the lower slide forward
again.
5 Removing stuck fasteners from the driving channel
•
Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
remove the nails. Use pliers to remove jammed fasteners from the magazine. Then reconnect the tool to the
compressed air supply and refill it with nails
6 EU Declaration of conformity
The Joh.
Friedrich
Behrens AG, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------------- -----------------------------------------------------------
Tobias Fischer-Zernin, Management Joachim Bauer, Documentation responsible