Klutch 62082, Руководство пользователя

Страница: 20 / 29

Page 20 of 29
4. After ensuring that the rotation switch is in the FOR position, the tension knob has been
tightened, and the power-feed lever is in the F (down) position, press the foot switch to start
feeding the cable further into the drain.
5. If the cable becomes lodged (in a narrow part of the drain, in a drain trap, etc.), move the power-
feed lever to exactly between the F and the R settings, otherwise the cable will start moving
which will allow the cable to work itself past the obstruction.
6. If the cable still won
’t pass the obstruction, release the foot switch and use sharp downward
thrusts to try and pass the obstruction. Once the cable is past, put the power-feed lever in the F
(down) position, press the foot switch, and continue feeding.
Note:
The rotation switch controls the rotation of the drum only. DO NOT USE THE
ROTATION SWITCH IN THE REV POSITION WHILE REMOVING THE CABLE
FROM THE PIPE.
Only use the reverse direction momentarily for relieving pressure or untangling the
cable from a blockage. The warranty will be void if the cable is damaged from allowing the motor to
twist excessively against a blockage, or if the drum is run in reverse long enough to unwind the cable.
Working Through a Blockage
1. If the cutting tool becomes lodged in a blockage and the drain cleaner is still operating, the cable
will start to wind up or twist. If so, release the pressure from the foot switch and the drain
cleaner motor will stop.
⚠
WARNING
Wound up loose cable outside of the drain can become a hazard. The cable can whip around,
causing serious injury. Do not let cable build up outside drain.
2. The cable and the drum will automatically turn backwards until the tension in the cable is
released.
⚠
WARNING
Do not remove your gloved hand from the cable until all the tension is released.